T&D RTR-500 Introductory Manual
Also see for RTR-500: Introductory manualManual
                                    | |
Contents
| 
7IntroductionCompliance InformationRadio, EMC and Safety RegulationsThis device complies with Part 15 of the Federal CommunicationsCommission (FCC) rules and with RSS-210 of the Industry Canada(IC). Operation is subject to the following two conditions: (1)Thisdevice may not cause harmful interference, and (2)this device mustaccept any interference received, including interference that maycause undesired operation.FCC StatementThis equipment has been tested and found to comply with the limits for a Class B digitaldevice, pursuant to Part 15 of the FCC Rules. These limits are designed to providereasonable protection against harmful interference in a residential installation. Thisequipment generates, uses and can radiate radio frequency energy and, if not installedand used in accordance with the instructions, may cause harmful interference to radiocommunications. However, there is no guarantee that interference will not occur in aparticular installation. If this equipment does cause harmful interference to radio or televi-sion reception, which can be determined by turning the equipment off and on, the user isencouraged to try to correct the interference by one or more of the following measures:- Reorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver.- Connect the equipment into an outlet on a circuit different from that to which the receiver isconnected.- Consult the dealer or an experienced radio/TV technician for help.To comply with the limits for the Class B digital device, pursuant to Part 15 of the FCCRules, this device must be installed in computer equipment certified to comply with theClass B limits.All cables used to connect the computer and peripherals must be shielded and grounded.Operation with non-certified computers or non-shielded cables may result in interferenceto radio or television reception.Caution: Changes or modifications not expressly approved by the party responsible forcompliance could void the user's authority to operate the equipment.Note about Antenna UsageThis device has been designed to operate with the supplied antenna only. Use of anyother antenna is strictly prohibited.Important NoticeWireless products cannot be used in countries other than where those products havebeen approved for use, according to that country's wireless regulations.T&D Corporation shall in no manner whatsoever take responsibility for the usage of theseproducts, nor be liable in any manner for legal consequences stemming from the usage ofthese wireless products in unapproved areas. |
Related manuals for T&D RTR-500
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine