Tanita 2000 Instruction Manual

Contents

Tanita 2000 Instruction Manual Manual pdf 5 page image

Important Features of the UltimateScaleThe UltimateScale allows you to measure both weight and body fat percentage simultaneouslyas easily and simply as stepping on an ordinary scale.The setting can be adjusted for an adult or child with moderately active to inactive lifestyles,increasing the accuracy of the body fat reading.Switching the Weight ModeThe UltimateScale can record weight measurements in lb (pounds), kg (kilograms) or st-lb(British stone-pounds). To select your preferred weight mode, make sure the scale is off. Pressthe Green Arrow and Orange Set buttons simultaneously. Press the Green Arrow button tochoose your measurement mode (lb/kg/st-lb), then press the Orange Set button. The displayscreen will flash to confirm your selection and store it in memory.Note: If weight mode is set to pounds or stone-pounds, the height programming mode will beautomatically set to feet and inches. Similarly, if kilograms is selected, height will be automaticallyset to centimetres.Automatic Shut-Down FunctionThe automatic shut-down function turns the power off automatically in the following cases:• If you interrupt the measurement process. The power will shut down automatically with-in 10 to 20 seconds, depending upon the type of operation.• If an extraordinary weight is applied to the platform.• If you make a mistake during measuring.• After you have completed the measuring process.Note: If the power shuts off unexpectedly, repeat the measuring process.Getting StartedInserting the Batteries1. Locate the battery cover on the back of the measuring platform. Press the tab to releasethe cover as shown.2. Insert the supplied AA-size batteries as indicated.Note: Be sure that the polarity of the batteries is set properly. If the batteries are incorrectlypositioned, the fluid may leak and damage floors. If you do not intend to use this unit for a longperiod of time, it is advisable to remove the batteries before storage.Positioning the ScalePlace the scale on a hard, flat surface where there is minimal vibration to ensure safe andaccurate measurement.Note: To avoid possible injury, do not step on the edge of the platform.Attaching the Support Feet (Carpet Use Only)Support feet are not needed for hard floor use. When measuring on carpeting, insert the sup-port feet into the holes at the four corners on the bottom of the measuring platform.Note: Do not use the scale on any carpeting that is more than 0.8" (20 mm) in thickness.Do not use the support feet on hard, flat surfaces, as the unit may tip over.3Open as shown.Direction of the batteries.Place the scale on a hard,flat surface.When measuring on carpeting,insert the support feet.Press the Green Arrow andOrange Set buttons simultaneously.Press the Green Arrow button to chooseyour measurement mode (lb/kg/st-lb),then press the Orange Set button.Instruction Manual (English)