General Cleaning:ontinued)The door is heavy. For1safe, temporary storage, lay the door|flat with the inside of the door facing/down. /To Remove and Replace Oven DoorTo Remove Oven Door:1. Open the door.2. Remove screws located on the inside of the oven door near the hinges A3.4.(one on each side.)Close the door to the quarter-open position. Grasp the door firmly on bothsides and lift up and offthe hinges.To clean oven door, follow the instructions provided in the cleaning chartunder General CleaningUff €lo_ straight off 2 door hin_sGeneral CleaningFigure 1Figure 2To Replace Oven Door:1. Be surethe hinge arms are in the quarter-open position. Be careful if pullingthe hinges open by hand. The hinges may snap back against the oven frameand could pinch fingers.2. Hold the door at the sides near the top. Insert the hinge arms into slots atthe bottom of the door.3. Hinge arms must go into the range slots evenly. The hinge arms should beinserted into the bottom corners of the door as far as they can go.4. If the door is not in line with the oven frame, remove it and repeat the abovesteps.To Remove and Replace Oven BottomTo Remove Oven Bottom:1. Remove the oven racks.2. Remove the two hold-down screws (Figure 1) at the rear of the ovenbottom panel. If the screws are too tight to remove by hand, use ascrewdriver.3. To lift out the bottom panel, place fingers in the slots in the bottom. Liftthe rear of the panel up and back until it is clear of the lip at the front ofthe panel (Figure 2).4. Lift the bottom up and out.To Replace the Oven Bottom:1. Place the oven bottom in the oven with the back raised about 6= or untilyou can insert the front of the oven bottom under the hold-down lip at thefront of the panel.2. Push the back of the oven bottom down fully into place on the metalflanges and insert the hold-down screws.13