Targa DVR-5200x User's Manual And Service Information
                                                              | |
Contents
| 
45RECORDINGRecording from an External Input (Continued)What is DV?You can connect a DV-equipped camcorder to thisrecorder using a single DV cable for input and output ofaudio, video, data and control signals.• This recorder is only compatible with DV-format(DVC-SD) camcorders. Digital satellite tuners andDigital VHS video recorders are not compatible.• You cannot connect more than one DV camcorder ata time to this recorder.• You cannot control this recorder from external equip-ment connected via the DV IN jack (including twoDVD recorders).• It may not always be possible to control the connect-ed camcorder via the DV IN jack.• Digital camcorders can usually record audio as stereo16-bit/48kHz, or twin stereo tracks of 12-bit/32kHz.This recorder can only record one stereo audio track.Set DV Record Audio to Audio 1 or Audio 2 asrequired (see page 27).• Audio input to the DV IN jack should be 32 or 48kHz(not 44.1kHz).• Picture disturbance on the recording may occur if thesource component pauses playback or plays anunrecorded section of tape, or if the power fails in thesource component, or the DV cable becomes discon-nected.• Although DV Record Audio is set to Audio 2 andAudio 2 signal is not present, DV Record Audio will bereset to Audio 1 automatically.DV-Related MessagesYou may see the following messages appear on yourTV screen when using the DV IN jack.Not connected to Camcorder.The camcorder is not connected properly, or the cam-corder is switched off.Too many devices connected.The DV jack on this recorder supports connection tojust one camcorder.Check the tape.There is no cassette loaded into the connected equip-ment.Uncontrollable device.This recorder cannot control the camcorder.Updating the information.Camcorder is updating the information for DV.Camera mode.Camcorder is set to camera mode.TroubleshootingIf you can’t get a picture and/or audio through the DV INjack, check the bullet points:• Make sure the DV cable is properly connected.• Try switching off the connected equipment thenswitch back on.• Try switching the audio input.otes• Depending on the connected camcorder, you may notbe able to control it using the remote control suppliedwith this recorder.• Before you set the mode of your Camcorder to cam-era mode, turn down the volume of connected Sounddevice. There can be a howling sound. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine