Tascam CC-222MKIV Owner's Manual

1 – Introduction30 TASCAM CC-222MKIV7 – Cassette operatingNote the following when loading tapes:1 Use your finger or a pencil to turn the cassette's huband take up any slack tape.NOTEAvoid touching the tape. Fingerprints attract dust anddirt.2 Press the EJECT key to open the cassette compart-ment door.3 Load the cassette tape with its open edge facingdown.4 Gently close the compartment door.NOTEThe cassette holder cannot be opened during record-ing or playback.If the power has been switched off during play orrecording, ejecting the cassette may be impossible. Insuch a case, switch the power on and press the EJECTkey again.Continuous tape/CD playback1 Load the tape as described above into the unit.Load the disc recorded side downwards into theunit.2 Press the CD-TAPE CONT PLAY key.3 Press either of the PLAY keys of the tape deck or theCD deck.Playback will start on the appropriate unit. Whenplayback reaches the end of the disc, or the end ofthe tape as determined by the REV MODE setting,playback starts on the other unit.NOTEMedia (tape or disc) can be changed in the unit that isnot playing.4 To stop playback and cancel the mode, press theCD-TAPE CONT PLAY key again.NOTEThe cassette deck and CD deck can be used to playback through different outputs, or the LINE OUTPUTS2 jacks can be used for both disc and tape playback(see “OUT2 setting (TAPE or AUTO)” on page 33 fordetails). However, note that if both are playing, thecassette takes priority (the disc will not be heardthrough these outputs).The LINE OUTPUTS1 jacks always output the audiofrom th edisc.Playback operationsWARNINGIf you are monitoring using headphones, first adjustthe level control to low on the unit, then connect to thePOHNES jack before playing back. This will preventany possible damage to your hearing.1 Set the REV MODE switch to the required tapemode.Ä Single-sided playbackË One side, then the other side, then stopä One side, then the other side, then the first sideagain, etc.Also, check the MONITOR switch is set to TAPE.2 Load a pre-recorded cassette with its open edge fac-ing down and side A facing toward you.3 Press either PLAY key to start playback.4 Adjust the volume with the amplifier’s volume control.5 To stop playback, press the STOP key.