Tascam CD-302 Owner's Manual

2 • Front and rear panels—Remote control unit (rear)14 TASCAM CD-302S A and B keysUse the A and B keys to set, edit and recall the startand end points of the loop, respectively.When you have set a loop (start and end points havebeen set), the A and B keys will light.T SAMPLE keyThis key lights when sample playback takes placeand flashes when sample recording takes place.Press and hold this key and press the IN key to enterreverse sample playback mode, and press and holdthis key and press the OUT key to enter loop sampleplayback mode.U IN/OUT keysUse these keys to set and clear the start and endpoints of the sampled sound and edit the end point.When you have set these points, these keys will light.Start and stop sample playback using these keys.V SCRATCH keyTurns the scratch play mode on and off. When thisscratch mode is active, the indicator lights (see 4.9,“Scratch”).When the indicator is lit, the playback can be“scratched” using the dial.W BRAKE keyTurns the brake mode on and off (see 4.14, “Brakefunction”). When the brake mode is active, the indi-cator lights.X + and – keysChanges the key.These keys have no effect in Original Key mode.Y KEY ORIGINAL/RESET keyUse to choose between the Original Key mode andand the Pitch Control mode (where the tempo or thekey may be changed independently of each other).Z TEMPO 8%/16%/32% keySelects the maximum amount by which you canchange the tempo and key (“width”).Repeated presses of this key cycle between 8% →16% → 32% → 0.0% → 8%.The width is briefly shown in the display for a fewseconds each time it is changed.a TEMPO sliderChanges the tempo when playing back a disc.The center position is the normal tempo.Push the slider up to the – position to decrease thetempo to the minimum set by the TEMPO key Z,and push it down to the + position to increase thetempo to the maximum value allowed.2.4 Remote control unit (rear)b REMOTE connectorsConnect these to the REMOTE connectors on the rearof the main unit 5.