Tascam CD-302 Owner's Manual

4 • Advanced Operations—Voice Reduce function26 TASCAM CD-3021 Press the PRESET key.2 Select 09 SAMP/R (SAMP_R) using the dial ornumeric keys.3 Press the ENTER key.4 Select On or Off using the dial.5 Press the ENTER key.However, even if the sampling point recall is set tooff, memorized sample data can still be loaded later:1 Recall the memory (see 4.10.2, “Recalling amemory”). If sample points have been storedin the memory, the IN and OUT keys will flashthree times.2 Pause playback.3 Press and hold the OUT key for more than twoseconds.The sample data are loaded, and the IN andOUT keys will light.4.10.6 Clearing memoriesIt is possible to clear all memories together, or clearthem individually.To clear individual memories:1 Recall the memory.2 M will show on the display.3 Press and hold the MEMORY key J for twoseconds or longer.4 The M in the display will go out.To clear all memories.1 Press the PRESET key.2 Select 24 ALL/CL (ALL_CL) using the dial ornumeric keys.3 Press the ENTER key. The display will show-SuRE- (-SURE-).4 Press the ENTER key to confirm the deletion ofall memories.NOTEIf you are clearing all memories and then turning offthe power, wait a few seconds between pressing theENTER key and turning off the power.4.11 Voice Reduce functionThis function lowers the volume of the vocal part ofthe material being played back when enabled. Notethat this may work better on some recordings thanothers.1 Press the PRESET key.2 Select 10 VOICE/R (VOICE_R) using the dialor numeric keys.3 Press the ENTER key.4 Select On or Off using the dial.5 Press the ENTER key to confirm this setting.4.12 Programmed playbackAdd up to 30 tracks to a program for programmedplayback in a series of program steps.Even when the power is turned off, if you have set aprogrammed playback order set and enabled timerplay, programmed playback will start when the unitis turned on, as the program is stored in memory.4.12.1 Setting the program stepsThis adds tracks as program steps in a new program.1 Press the PRESET key.2 Select 11 PROG (PROG) using the dial ornumeric keys.3 Press the ENTER key. The program step num-ber and the track number are shown on thedisplay.4 Use the SKIP keys C to select the track to beplayed as the currently-shown program step.5 Press the ENTER key to confirm the entry.6 Repeat 4 and 5 above for as many steps as willbe entered into the program.7 To finish the program entry sequence, pressthe PRESET or ENTER key (or any key exceptthe SKIP keys).4.12.2 Adding tracks to the middle of aprogramWhen you have created a program, you can inserttracks as new program steps part of the way throughthe program.1 Press the PRESET key.