1DA-60 MK IIQUICK TIPSNote: Whenever this document directs you to “Hold SHIFT and press MENU s or t” toarrive at a particular screen, you can use the alternate procedure of “Hold SHIFT whilerotating the DATA DIAL.” While both methods accomplish the same task, you may findrotating the Data Dial preferable.After changing system parameters in the various edit screens, pressing either MENU s ort will exit you back to the main screen.AUTO CUE (Cue to Modulation)1) This function requires use of the Memory Start feature, and its performance isdirectly affected by the Auto Cue Sensitivity levelAUTO CUE SENSITIVITY LEVEL1) Hold SHIFT and press MENU s or t until you arrive at screen #6 "AtcuE"2) Press DATA, current parameter value will blink (Memory Start Standby mode mustbe disengaged)3) Rotate DATA DIAL either clockwise or counter clockwise until desired value isdisplayed4) Press SET to confirm new parameter valueCAPTURE OFFSET1) Hold SHIFT and Press MENU s or t until you arrive at screen display “-tc-cLoSE”(if display reads “oPEn”, proceed to step 3)2) Press DATA (“cLoSE” will blink), rotate DATA DIAL to “oPEn” - press SET3) Press MENU s or t until "n CHASE OFFSET" appears in the upper right display4) While holding SET, press CHASE - the smaller of the two Time Code displays willbe the current offset valueNote: It is assumed that Time Code is being fed to the DA-60 MK II from an externaldevice.To Trim or Clear the Offset:5) Press MENU s or t and select "n CHASE OFFSET"6) Press DATA - the "hour" digits of the offset screen will blink and successivepresses of DATA enable you to cycle from "minutes" to "seconds" to "frames" to"sub frames" and back to "hour"7) Enter the desired value using the DATA DIAL and DATA key - upon completion,press SET