Tascam DM-24 Effects Manual

Also see for DM-24: User guide Basic guide Quick start guide Basic guide Installation information

1 – Internal Effects on the DM-24—Effect send sources6 TASCAM DM-24 Effectson the OUT section of the screen when the loopassignment is made and is shown as Chxx (xx = 1through 32). If no channel has been assigned, the dis-play shows ---. If more than one channel has beenassigned as a return, the display shows ****.Aux 1 through Aux 6 insert When these areselected as effect input sources (AUXx INS SEND), theeffect becomes an insert-type effect.This insert is made post aux send fader.The outputs of the effect are automatically assignedto the appropriate aux insert returns and shown asAUX INS RETURN.Buss 1 through buss 8 insert When these areselected as effect input sources (BUSSx INS SEND), theeffect becomes an insert-type effect.This insert is made post buss level fader.The outputs of the effect are automatically assignedto the appropriate buss insert returns and shown asBUSS INS RETURN.Stereo L, R insert When these are selected aseffect input sources (ST-L PRE SEND and ST-R PRESEND), the effect becomes an insert-type effect.This insert is made pre stereo master fader.The outputs are automatically assigned to the stereoinsert returns are shown as ST-L PRE RETURN and ST-RPRE RETURN.Assignable inserts 1 through 4 When theseare selected as effect input sources (ASGN INSx SEND),the effect becomes an insert-type effect.For these to be effective, the assignable send/returnsmust be set to be inserts, not send/return loops (see“Assignable sends and returns” on page 43 of themain manual). If they have been set to send/returnloops, a popup message appears informing you of thefact.Note that when an assignment is made to theseinserts, the corresponding physical 1/4” jacks are nolonger available (these settings override the physicaljack insert assignments).The outputs from the effects are sent to the assign-able insert return. This is shown in the output assign-ment section of the effect as ASGN INSx RTN CH y if achannel assignment has been made, or ASGN INSx RTN--- if no assignment has been made.Effect 1-2 seriesWhen the two effects units are selected to act inseries, with effect 1 feeding effect 2, although botheffect 1 and effect 2 are shown on the screen, only theinputs to effect 1 may be set.The output(s) from effect 1 are automatically routedto the input(s) of effect 2.If the source of effect 1 is an aux send, the effect 2output is assigned to a channel (set using the I/Oscreen).If the source of effect 1 is an insert, the output ofeffect 2 defaults to the insert return as shown in theoutput assignment section of effect 2.The outputs from effect 1 are shown as EFFECT2 IN Land EFFECT2 IN R, and the inputs to effect 2 are shownas EFFECT1 OUT L and EFFECT1 OUT R (if effect 2 is adual-channel effect).If channel 2 is set to output only a single channel, thesingle output from effect 1 is labeled as EFFECT2 IN Land if there is a single input to effect 2, this is labeledEFFECT1 OUT L.