Tascam IF-FW/DM Owner's Manual
Also see for IF-DM: Owner's manualOwner's manual
            | |
TASCAM IF-FW/DM Owner's ManualOInstallationInstalling the IF-FW/DM1. Remove the five screws holding the blankplate or card currently installed in Slot 1then remove the plate or card.2. Insert the IF-FW/DM into Slot 1, mak-ing sure that the card edges slide into thewhite plastic guide inside Slot 1. Push itall the way in until it clicks and the cardback plate is flush with the mixer’s backpanel. Excessive force is not required - ifit does not click in easily, remove it andstart again with attention to the guides.3. Replace the five screws to hold the card inplace.NOTE• The IF-FW/DM must be installed in to themixer’s Slot 1. It will not function in Slot 2.• The following installation must be done withthe mixer’s power OFF and disconnected.There is a series of jumpers on the IF-FW/DM that set its operating mode. These jump-ers must be in the correct position to operatewith a DM-3200 or DM-24, which com-municate with the IF-FW/DM via differentoperating modes.Early IF-FW/DM cards shipped configuredfor the DM-24. From the time of DM-3200software version 1.20 availability, IF-FW/DM cards began shipping configured for theDM-3200.Please confirm your card’s configurationwith the following pictures and instructionsthen make any necessary changes beforeinstalling the IF-FW/DM into your mixer.NOTE• The IF-FW/DM will not function if incor-rectly configured for your mixer. Installingan incorrectly configured card will not harmanything.• The IF-FW/DM must be installed in eithermixer’s Slot 1. It will not function in Slot 2.Use commonly available needle-nose pliersto carefully change the configuration of thecard as shown.Picture 1 is IF-FW/DM Configured for aDM-3200. Note that jumpers J11 throughJ43 are across pin rows 2 and 3.Picture 2 is IF-FW/DM Configured for aDM-24. Note that jumpers J11 through J43are across pin rows 1 and 2.Configure For Your MixerJ11 - J43SDT : 1-2 (default)LVDS : 2-3Card edgeU43U42U41U40U26U25U24U23U35U34U32U31U18U17U16U15U39U38U37U36U22U21U20U19U30U29U28U27U14U13U12U11123321For DM-24Picture 2J11 - J43SDT : 1-2 (default)LVDS : 2-3Card edgeU43U42U41U40U26U25U24U23U35U34U32U31U18U17U16U15U39U38U37U36U22U21U20U19U30U29U28U27U14U13U12U11123321For DM-3200Picture 1 |
Related manuals for Tascam IF-DM
manualsdatabase
Your AI-powered manual search engine