TASCAM IF-FW/DM Owner's ManualOSetupThe IF-FW/DM appears to a mixer just likeany other optional I/O card except that it has24 channels of I/O instead of 8.IF-FW/DM & Mixer RoutingMixer OutputsDM-3200By default, the DM-3200 duplicates busses 1- 8 on IF-FW/DM mixer outputs 17 - 24.Also available are the Direct Outputs fromchannels 1 - 16. By default, those appear onIF-FW/DM mixer outputs 1 - 16.These routing settings can be changed in theOUTPUT tab of the DM-3200’s ROUTINGscreen.If it becomes necessary to switch between44.1k and 48k sample rates on the mixer,the following steps are required for correctoperation:1. Disconnect the FireWire cable betweenthe DM-24 and the IF-FW/DM.2. Change the sample rate on the DM-24.3. Re-connect the FireWire cable.NOTE30 seconds must elapse between disconnec-tion and reconnection of the FireWire cable.96 k & 88.2 k OperationThe IF-FW/DM does not support these sam-ple rates.System ClockingWhen configured with the IF-FW/DM, themixer must be the master clock relative tothe computer DAW. The mixer itself may beclocked to an external source other than theDAW.Master ClockClock Settings