Tascam MX-2424 Operational Tutorial

Also see for MX-2424: Release note Instructions Manual update Quick reference guide Install guide

Contents

- 22 -FIRST SESSIONFIRST SESSIONFIRST SESSIONFIRST SESSIONLoading the Factory DemoThe MX-2424 doesn't automatically load a project when it is powered up. It leaves thedecision of which project you want to load up to you. If you have just connected yourMX-2424 to your mixing board, it can be helpful to load the MX-2424 Demo Song tobecome familiar with the MX-2424’s operation. This will also give you 24-tracks ofmusic to check all of your connections.Loading the Factory Demo Song1) Turn your MX-2424 on using the rocker type power switch on its face. Give it aminute to boot up. You will see the message, "Mounting Volumes," on the LCD. When itis finished booting and ready to run, the LCD will read,MX-01 01:00:00:0000:00:00:002) Press [PROJ/NEW]. The button's associated LED will light and the [STORE/YES]LED will flash. The LCD will read,Load* Select Action3) Press [STORE/YES]. Then use the [Up Arrow] or [Down Arrow] to scroll to theproject titled, "Warmness.tl" (if this is the very first time you have booted your MX-2424,it may be the only project listed or by the time you read this, there may be a differentproject pre-loaded). The LCD screen should look like this,Load ProjectWarmness.tl [0:23]4) Press [STORE/YES]. You will hear the hard drive working and the DISK LED willilluminate for a few seconds as your MX-2424 loads the project.5) Double click the [REW] button and press [Play] to have a listen.• HOT TIP! — To load any project, follow Steps 1 to 4. But instead of choosing theDemo Song in Step 3, select a different project to load.