SPECIAL KEY COMBINATIONSPressing TO and FROM simultaneously then IN or OUT will play THRU the In or Out point using the pre andpost roll values set in Menus 212 & 213.Pressing IN and OUT simultaneously will play from the In point and stop at the Out point. (IN OUT)Pressing LOOP [26] plus LOCATE [27] sends the MX to the Pre-Roll point before the IN point value.Press PLAY [32] and REW [35] simultaneously to play backwards.These functions are available from the MX-2424 and the RC-2424.OFFSET/TC READER[30, 31] From the MX-2424Pressing IFT> [19] then INFFSET> [30] will recall the Offset Value into the bottom of the LCD [18] forviewing or editing.There are two internal offset values, one for time code and the other for the TL-Bus. If the TL-Bus Slave LED isON (Menu 110) and the Online button is on, then the TL-Bus offset is shown. In all other cases the time code (LTCor MTC) offset is shown. If the MX-2424 is a MASTER on the TL-BUS it will still display the LTC offset since theTL-BUS offset is ignored in this case.Pressing IFT> then OUT<TC READER> [31] will display incoming time code in the bottom of the LCD[18].[78] From the RC-2424Pressing OFFSET [78] will recall the Offset of the MX-2424 currently selected by the MACHINE SELECT [72]keys into the bottom of the LCD [18] for viewing or editing.Pressing IFT> then OFFSET <TC READER> [78] will display incoming time code from the MX-2424currently selected by the MACHINE SELECT [72] keys in the bottom of the LCD [18].There are two internal offset values, one for time code and the other for the TL-Bus. If the TL-Bus Slave LED isON (Menu 110) and the Online button is on, then the TL-Bus offset is shown. In all other cases the LTC offset isshown. If the MX-2424 is a MASTER on the TL-BUS it will still display the LTC offset since the TL-BUS offset isignored in this case.27
