Taurus TF-QT1097 Assembly Instructions Manual

HIP THRUST QT1097144 TROUBLESHOOTING, CARE AND MAINTENANCE4.1 General Instructions⚠ WARNING+ Do not make any improper changes to the equipment.⚠ CAUTION+ Damaged or worn components may affect your safety and the life of the equipment.Therefore, immediately replace damaged or worn components. In such a case, contact thecontract partner. The equipment must not be used until it has been repaired. If necessary,use only original spare parts. ࣑ATTENTION+ In addition to the instructions and recommendations for maintenance and care given here,additional service and/or repair work may be necessary; this must only be carried out byauthorised service technicians.4.2 Faults and Fault DiagnosisThe equipment undergoes regular quality controls during production. Nevertheless, faults ormalfunctions may occur. Frequently, individual parts are responsible for these disturbances, anexchange is usually sufficient. Please refer to the following overview for the most common errors andhow to correct them. If the equipment still does not function properly, contact your contract partner.Fault Cause SolutionSqueaking & crackingnoisesLoose or too tight boltconnection Check or lubricate bolt connection4.3 Maintenance and Inspection CalendarTo avoid damage from body sweat, the equipment must be cleaned with a damp towel (no solvents!)after each training session.The following routine tasks must be performed at the specified intervals:Part Weekly Monthly Quarterly Half-yearly YearlyScrews connections IPads and frames C/ILegend: C = clean; I = inspect