Basic OperationOSD MenuMultimediaOperationRecordingOperationUser GuidanceInformationMaintenanceand Service7Fixing the stand3. Warnings.1. The parts needed for installing the stand (supplied)TV set Stand Screws(supplied)4 x ST4 x 16F2. How to install the Stand?BackFrontFrontTop ViewFrontBefore installing the stand, please check thatyou have all of the parts and that there is novisible damage. If a part is missing or appearsdamaged, please contact customer service.Place the TV face down on a soft and flat surface (blanket, foam, cloth, etc.) to prevent any damage to the TV.Put the Stand to the neck of the TV set as shown below.1. Before you put on the stand, please make sure the direction is correctas shown below.2. When you are putting on the stand, please make sure the neck of theTV set is in the correct position and attached tightly.If you do not attach the stand correctly, it will make the TV unstableand may tip over.Attach the stand with the supplied screws.When attaching the stand, make sure the screwsare attached tightly.If the screws do not attach tightly, it will lead the TVto be unstable or may even tip over.a. It can not be tilted to the front or back asshown below. Doing so may damage thestand.b. It can not be tilted to the right or left as shown below.Doing so may damage the stand.