U-Line H-10268 Assembly Instructions Manual

PAGE 13 OF 42 0323 IH-10268OPERATION CONTINUEDCOLLISION PREVENTION SENSITIVITYADJUSTMENTPress and hold or button for five seconds at thesame time to switch the sensitivity.A-0: Turn off anti-collision functionA-1: Low sensitivityA-2: Medium sensitivityA-3: High sensitivityWORKSTATION DUTY CYCLE• To protect the motor from overheating, the heightcan only adjust consistently for two minutes.• If E01 or E02 error code shows on display panel,workbench has reached its usage limit. Allow 18minutes for motors to cool down and code willautomatically be removed.TROUBLESHOOTINGOPERATING ISSUE RECOMMENDATIONSDesktop will not function. Check power cord connections. Ensure power cord is properlyplugged into the power outlet.Check power source.Desk rises at low speed.Desk moves downward without any operation.Desk automatically self-resets.Check if overloaded. Max loading: 500 lbs.Remove load on table.Desk only moves in one direction. Reset.Overload.(Duty cycle: Max – 2 min on/18 min OFF)"EO1" "EO2" shows on screen.Restart after 18 minutes.Display shows ASr or rSt. Press and hold until desk runs to lowest position andcomes to stop. Display will show lowest height. Release .Reset completeAdditional codes show on screen. Press . If no response check power cord connections.Power off for more than 10 seconds, reconnect power. Thedisplay will show ASr or rSt. Press and hold to reset.If the troubleshooting section does not resolve your problem, contact Uline Customer Service at 1-800-295-5510.