U-Line METRO H-10306 Manual

PAGE 3 OF 24 0424 IH-10306ASSEMBLYSTORAGE CABINETOpen H-10295 carton first to assemble storagecabinet in steps 1-11.NOTE: Assemble unit on a smooth, non-marringsurface to prevent scratching. Check that allparts are included.IMPORTANT! Turn cam lock 1/4 to the right tolock.IMPORTANT! Cam lock pins must be tightenedonce inserted into panel. To tighten cam lockpins, grasp lower part of cam lock pin andtighten using a Phillips screwdriver.TIGHTENING OF CAM LOCK PINSNOTE: Use Phillips screwdriver to tighten camlocks, cam lock pins and screws.NOTE: Cam lock caps (I) can be applied oncecam locks are tightened for a finished look.1. Install one cam lock pin (D) in bottom panel (4).Insert one cam lock (E) into corresponding holein skirt panel (6). Fit bottom panel and skirt paneltogether and tighten cam lock. (See Figure 1)64Figure 1EDDD E442. Install two cam lock pins (D) and two dowels (G)in back panel (5). Insert two cam locks (E) intocorresponding holes in bottom panel (4). Fit backpanel and bottom panel together and tighten camlocks. (See Figure 2)45DG DFigure 2E5 54Hold whiletighteningIMPORTANT! FUNCTION OF CAM LOCK1/4 RIGHT TURNFOR LOCKINGEnsure the arrow is pointing toward edge ofpanel before inserting into the panel's hole.