Ubiquiti PBE-M5-300-US Quick Start Manual

Also see for airMAX PowerBeam PBE-M5-300: Quick start guide Quick start guide

Reset ButtonRelease ButtonSignal LEDsEthernet LEDPower LEDLAN and DHCP server.To reset to factory defaults, press and hold the Reset button for more than 10seconds while the device is powered on. Alternatively, the device may be resetremotely via a Reset button located on the bottom of the PoE adapter.After you assemble the device, check the Release button; it should be fullyengaged in the Release Button Slot of the Rear Housing. This ensures that theAntenna Feed is locked into place. If you need to remove the Antenna Feed, youmust depress the Release button first.In airOS®, you can modify the threshold values for the wireless signal strengthLEDs on the Advanced tab under Signal LED Thresholds. The default values areshown below:The Ethernet LED will light steady green when an active Ethernet connection ismade and flash when there is activity.The Power LED will light green when the device is connected to a power source.Application ExamplesThe PowerBeam mounted outdoors with the Reflector installed provides directionaloutdoor coverage (gain is reflector-dependent).PBE-M5-300 Quick Start Guide