3. At the installation site, secure the other end of the groundwire to a grounded mast, pole, tower, or grounding bar.WARNING: Failure to properly ground yourairFiber radio will void your warranty.Note: The ground wire should be as short aspossible and no longer than one meter in length.Mount to the airFiber AntennaFollow the instructions in this section to mount the AF‑11FX toan airFiber AF‑11G36 antenna:1. Attach the airFiber X radio to the antenna by aligning thefour tabs on the back of the radio with the slots of the radiomount. Then slide the radio down to lock it into place.

package contents

installation requirements

hardware overview

installation overview

connecting power

hardware installation

specifications

declaration of conformity

online resources

Ubiquiti airFiber 11FX Quick Start Manual

airFiber 11FX

Chapter 1: Overview

Chapter 2: Installation

Installing an Optional Duplexer (MIMO Mode)

Connecting Power over Ethernet

airFiber Configuration

Hardware Installation

Connecting Power

Alignment

Installer Compliance Responsibility

Chapter 3: Navigation

Interface

Chapter 4: Dashboard

Signal Strength

Ethernet

Chapter 5: Wireless Tab

Frequency Settings

Advanced Wireless Settings

Chapter 6: Network Tab

Data Port Ethernet Settings

Ethernet Carrier Drop Settings

Chapter 7: Services Tab

SNMP Agent

NTP Client

Chapter 8: System Tab

Device

Chapter 9: Tools

Discovery

file menu

Appendix J: Specifications

Appendix K: Safety Notices

Appendix L: Warranty

Appendix M: Compliance Information

RoHS/WEEE Compliance Statement

Appendix N: Declaration of Conformity

Appendix O: Contact Information

AF-11FX-H

AF-11FX-L