HT10 - HT11 - HT2016 Ugolini S.p.A.5. 3. 5 ASSEMBLY1 - Slide drip tray with its cover into place.2 - See 5.3.6 FAUCET ASSEMBLY paragraph3 - Fit bowl gasket to the bowl leaving the thickest part of itoutside the bowl (see figure 9).figure 94 - Place bowl on the unit, with gasket around the coolingdome, then push it down all the way.Wet cooling dome and gasket for ease of insertion.5 - HT11 - HT20 PS lines: raessemble pump assembly; placeit into bowl location and turn it counterclockwise until itstops into position.6 - HT10 - HT20M lines: replace stirrer onto its shaft and dropit into place freely.5. 3. 6 FAUCET ASSEMBLY5. 3. 6. 1 HT11 - HT20 LINES WITH PINCH TUBEFAUCET1 - Fit the faucet cover and the faucet body by reversingdisassembly operations (see figure 5).2 - Push (1) the dispensing handle and insert (2) the pinchtube into its vertical seat in the bowl bottom (see figure 10).figure 103 - Lightly pull (3) the pinch tube end downwards till it is wellarranged. (see figure 11).figure 115. 3. 6. 4 HT11 - HT20 LINES WITH GRAVITYFAUCET1 - Fit the faucet body by reversing disassembly operations(see figure 7).2 - Install the faucet handle (1-2) and the piston with its gasket(3) (see figure 12).figure 125. 3. 6. 3 HT10 LINE1 - Fit the faucet cover and the faucet body by reversingdisassembly operations (vedere figure 5).2 - Insert the pinch tube into its horizontal seat in the bowlbottom (see figure 13).figure 133 - Insert the pinch tube end into the faucet body vertical seat(see figure 14).figure 144 - Push (1) the dispensing handle and pull the pinch tube end