Unicla A Series Service Manual
                    | |
7.Removal of clutch assemblyI. Removal of fixing screw on armatureTools required: • Stand • Clutch wrench• Wrench • 10mm SocketProcedure: Place the compressor on the stand. Hold clutch byinserting the claws of the clutch wrench into the holes on thearmature. Remove the centre bolt by using the wrench.II. Removal of armatureTools required: • Hub remover • WrenchProcedure: Pull the armature upwards.III. Removal of snap ringTools required: • Snap ring pliers (shaft)Procedure: Remove the snap ring with the snap ring pliers.IV. Removal of pulley assemblyTools required: • Remover, pulley • Wrench • Pulley padProcedure: Remove the pulley assembly with the remover.V. Removal of coil (3 bolt type)Tools required: • Standard screwdriverProcedure: Remove 3 M5 bolts with screwdriver.Removal of coil (snap ring type)Tools required: • Snap ring pliers (shaft)Procedure: Remove the snap ring with pliers as shown.VI. Inspection of clutch components1. Armature - Contact surface must be clean, smooth andunmarked, with no abnormal scoring.2. Pulley - Contact surface must be clean, smooth andunmarked, with no abnormal scoring.3. Coil - Wiring harness must be in good condition.ArmaturePulleyCoilHub removerWrenchClutchwrenchSnap ringPulleypadSnap ring pliers(+) Driver |
Related manuals for Unicla A Series
manualsdatabase
Your AI-powered manual search engine