Uniden UH060SX-2 Operating Manual

Contents

Uniden UH060SX-2 Operating Manual Manual pdf 4 page image

4Place the UH060SX-2 into the charge cradle. The charge light willcome on to indicate the unit is charging. Before operating theUH060SX-2, charge the battery pack for 16 hours.If the battery level becomes low, the batteryindicator icon on the display begins flashing.When the batteries in the unit are low, the unit will go into aBattery Low mode. The Transmit mode is disabled. Replace thealkaline batteries immediately or if you are using the NiMHbattery pack, place the radio on the charge cradle to recharge.Full charge will take up to 16 Hrs.Do not charge alkaline or nonrechargeable batteries.BELT CLIPLOW BATTERY ALERTTo attach the belt clip:Slide the belt clip until it snaps into place.To remove the belt clip:To remove the belt clip, press and hold beltclip locker, slide the belt clip at the sametime until released.INSTALLING THE CHARGE CRADLE• Plug the AC adaptor into the rear of the charge cradle andinto the mains power.UT928ZH_UH060_ENG_0929 9/29/04 3:26 PM Page 4