Uniden UH5045 Owner's Manual

Also see for UH5045: Manual

Uniden UH5045 Owner's Manual Manual pdf 25 page image

Operation25UNIDEN UH5045 UHF CB Transceiver50 RX ChannelsThe radio has 50 receive only channels (CH81 to CH130) which can be programmedwith frequencies ranging from 450-520MHz (in 12.5kHz steps).Manual ProgrammingTurn power off.Press and hold [DUAL/MON] at the base or [SQL/MON] on the Remote SPK/MICwhile turning power on (pressing power switch on the base or [POWER] on theRemote SPK/MIC).The channel indicator flashesthe lowest available emptychannel. You may use therotary channel selector at thebase or on the RemoteSPK/MIC to select anotherchannel from CH81 - CH130.Press [MEM]. The MHz digitsof the frequency indicator flashes. Turn the rotary channel selector at the base orpress on the Remote SPK/MIC to select the desired MHz.Press [ /MENU/ENTER] and [SCAN/OS/GS/ ] at the base or [ /OS/GS/SCAN] and[DCS/CTCSS/DUAL/ ] on the Remote SPK/MIC to change from the MHz digits to thekHz digits of the frequency, turn the rotary channel selector at the base or presson the Remote SPK/MIC to select the desired kHz.When finished press [MEM]. The channel indictor flashes. Turn rotary channelselector at the base or press on the Remote SPK/MIC to select next channel forprogramming or press and hold [MENU/ENTER] to store setting.A confirmation tone sounds. The channel is also entered into OS scan memory.Deleting a programmed RX Channel frequencyFollow the steps in Manual Programming to enter a frequency for a desired channel.Select 000 for the MHz digits and then press [MEM]. Select another channel to edit orpress and hold [MENU/ENTER] again to exit programming mode.