UnionSpecial 63900 Adjustment Manual

Also see for 63900 Series: Instructions for adjusting and operating

Contents

UnionSpecial 63900 Adjustment Manual Manual pdf 19 page image

19HOOK SHAFT (CONT.)To reposition the hook shaft, loosen the set screws of the pinion and collar and establish the 9/16 inchdimension. Move the pinion and thrust washer against the left bushing, and after making certain one of theset screws in on the shaft FLAT, tighten both screws securely. Liberally coat the collar and its washer withoil and press the collar away from the pinion so as to remove all end play and tighten both set screwssecurely.Hook oiling is accomplished by a high speed rotary pump on the end of the hook shaft. The quantity of oilsupplied to the hook is regulated by the longer or shorter path the oil is required to travel through themetering felt of metering cup (G, Fig. 23). (Increase or decrease of oil supply is controlled by a dial (P, Fig.23) with an arrow marked "INCREASE", found below the cloth plate.) The hook oil feed roller (A, Fig. 23) whichrests against the metering cup felt serves not only to feed oil to the unit from the oil reservoir, but filters theoil as well.REMOVAL OF OILING DEVICEThe following steps are necessary to remove hook oiling device:1. Remove hook oil feed roller (A, Fig. 23).2. Remove hook oil control finger (B).3. Apply finger pressure to hook oil control shaft (D) to prevent loss pump disc pivot pin (E); using Allenwrench, loosen set screw (C). Move assembly slowly to right, being careful not to drop pivot pinlocated on the end of the hook oil control shaft. When pivot pin is clear of pump disc (F), disc is freeto fall.4. Remove metering cup (G) along with oil supply felt (K) and air seal felt (J).5. Remove cop (H) from hook oil control shaft.