UnionSpecial 63900 Adjustment Manual

Also see for 63900 Series: Instructions for adjusting and operating

Contents

UnionSpecial 63900 Adjustment Manual Manual pdf 5 page image

5SAFETY RULES1. Before putting the machines described in this manual into service, carefully read the instructions. Thestarting of each machine is only permitted after taking notice of the instructions and by qualifiedoperators.IMPORTANT! Before putting the machine into service, also read the safety rules and instructions from themotor supplier.2. Observe the national safety rules valid for your country.3. The sewing machines described in this instruction manual are prohibited from being put into service untilit has been ascertained that the sewing units which these sewing machines will be built into, haveconformed with the EC Council Directives (89/392/EEC, Annex II B).Each machine is only allowed to be used as foreseen. The foreseen use of the particular machine isdescribed in paragraph “STYLES OF MACHINES” of this instruction manual. Another use, going beyondthe description, is not as foreseen.4. All safety devices must be in position when the machine is ready for work or in operation. Operation ofthe machine without the appertaining safety devices is prohibited.5. Wear safety glasses.6. In case of machine conversions and changes all valid safety rules must be considered. Conversions andchanges are made at your own risk.7. The warning hints in the instructions are marked with one of these two symbols:8. When doing the following the machine has to be disconnected from the power supply by turning off themain switch or by pulling out the main plug:8.1 When threading needle(s), looper, spreader etc.8.2 When replacing any parts such as needle(s), presser foot, throat plate, looper, spreader, feeddog, needle guard, folder, fabric guide etc.8.3 When leaving the workplace and when the workplace is unattended.8.4 When doing maintenance work.8.5 When using clutch motors without actuation lock, wait until the motor is stopped totally.9. Maintenance, repair and conversion work (see item 8) must be done only by trained technicians orspecial skilled personnel under consideration of the instructions.10. Any work on the electrical equipment must be done by an electrician or under direction and supervisionof special skilled personnel.11. Work on parts and equipment under electrical power is not permitted. Permissible exceptions aredescribed in the applicable sections of standard sheet DIN VDE 0105.12. Before doing maintenance and repair work on the pneumatic equipment, the machine has to bedisconnected from the compressed air supply. In case of existing residual air pressure, after disconnect-ing from compressed air supply (i.e. pneumatic equipment with air tank), the pressure has to beremoved by bleeding.