Unitech MS282e Quick Start Manual

Unitech MS282e Quick Start Manual Manual pdf 1 page image

MS282e 2D Imager Barcode ScannerQuick Start GuideFactory DefaultVersion 1.0608671GConnecting the Scanner* Default OptionUSB Device TypeScan ModeProduct InformationUSB COM Port EmulationConnect USB cable to the USB port of a host PC.Thank you for purchasing the unitech product.For other product documentation, please scan the QR code for more information.USB HID-KBWAiming On /OffTrigger mode* Sense ModeContinuous ModeNormal *OffGood Read LEDGood Read LED ON *Good Read LED OFFEnable/DisableAll Prefixes/SuffixesEnable All Prefixes/SuffixesDisable All Prefixes/SuffixesBarcode ProgrammingBefore starting scanning any setting barcode,please do follow the instruction below.Scanning the Enter Setup barcode can enable the engine toenter the setup mode. Then you can scan a number of programmingbarcodes to configure your engine. To exit the setup mode,scan the Exit Setup barcode.Enter Setup Exit Setup *USB HID-POSAlways OnPulse ModeBatch ModeTrigger Mode: A trigger pull activates a decode session.Sense Mode: The engine activates a decode session every time it detects a barcode presented to it.Continuous Mode: The engine automatically starts one decode session after another.Pulse Mode: When the trigger is pulled and released, scanning is activated until a barcode is decoded or the decodesession timeout expires.Batch Mode: A trigger pull activates a round of multiple decode sessions. This round of multiple scans continues untilyou release the trigger. Rereading the same barcode is not allowed in the same round.

/ 2

Related manuals for Unitech MS282e