44 © 2015 unitech Electronics Co., Ltd. All rights reserved.unitech is a registered trademark of unitech Electronics Co.,Ltd4.10 Setup InsertionTo setup the insertion of output characters :1. Scan the label of the desired set.2. Scan the label of the desired symbology.3. Go to the Numeric Bar Codes in Appendix A, scan label(s) that represents thedesired position to be inserted.4. Scan the “Complete” label of “Character Position to be Inserted”.5. Go to the ASCII Tables in Appendix B or Function Key Tables in Appendix C, scanlabel(s) that represents the desired characters to be inserted. Scan the “Complete”label of “Number of Characters to be Deleted”.6. Scan the “Complete” label of “Characters to be inserted”.Repeat the steps 1 – 6 to set additional insertion.A. Select Insertion Set Number1st Set 2nd Set 3rd Set4th Set 5th Set 6th Set
