Unitech MS842 User Manual

Also see for MS842: User manual Quick start guide User manual User manual

Contents

Unitech MS842 User Manual Manual pdf 57 page image

Code 93Enable/Disable Code 93To enable or disable Code 93, scan the appropriate bar code below.Set Lengths for Code 93The length of a code refers to the number of characters (i.e., human readablecharacters), including check digit(s) the code contains. Set lengths for Code 93 toany length, one or two discrete lengths, or lengths within a specific range.z One Discrete Length - Select this option to decode only Code 93 symbolscontaining a selected length. Select the length using the numeric bar codes in theappendix of Numeric Bar Codes. For example, to decode only Code 93 symbolswith 14 characters, scan Code 93 – One Discrete Length, and then scan 1followed by 4. To correct an error or to change the selection, scan the Cancel barcode.z Two Discrete Lengths - Select this option to decode only Code 93 symbolscontaining either of two selected lengths. Select lengths using the numeric barcodes in the appendix of Numeric Bar Codes. For example, to decode only Code93 symbols containing either 2 or 14 characters, select Code 93 – Two DiscreteLengths, and then scan 0, 2, 1, and then 4. To correct an error or to change theselection, scan the Cancel bar code.45Copyright 2013 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.