Unitech MS910 User Manual

Also see for MS910: User manual Quick guide Quick guide User manual Quick guide

Unitech MS910 User Manual Manual pdf 15 page image

11Unitech electronics co., ltd.5F., No.135, Ln. 235, Baoqiao Rd., Xindian Dist., New Taipei City 231, Taiwan (R.O.C.)y Tel: + 886 2 89121122 y Fax: +886 2 89121810 y website: www.ute.comChapter 4User PreferencesSetup ProceduresThis chapter describes the user-configurable settings for the MS910 and provides theprogramming bar codes for selecting these features for the scanner. To configure your MS910scanner:1. Locate the appropriate feature setting listed in the following pages.2. Set feature values by scanning single barcodes or short barcode sequences.3. The MS910 will beep to confirm a successful scan and will store the new setting in the scanner’smemory.Min. Length / Max. LengthStep 1: Scan MIN LENGTH or MAX LENGTH.Step 2: Scan two digits from Full ASCII Chart of Appendix A.Step 3: Scan MIN LENGTH or MAX LENGTH.NOTES:1. If the scanner beeps three times, it is an alert that a setting update is incomplete.2. If you make a mistake in attempting to update a scanner setting, such as accidentally scanningthe wrong barcode or forgetting a step, scan the [Reset] barcode below to start the process over.ResetDefault3. If you want to restore the scanner back to factory settings, please scan the [Default]barcode below.Bar Code Length SettingThe following examples illustrate how to set up Code 39 with a minimum length of 5 and amaximum length of 20, respectively.¾ Minimum length of 51. Go To "Group 4".2. Scan "MIN LENGTH" to enter minimum length setting.3. Scan "0 " and "5" to select length S. (Full ASCII Chart of Appendix A)4. Scan "MIN LENGTH" to end minimum length setting.