Unitech PA500II Quick Reference Manual

Also see for PA500II: User manual User manual

Contents

Charging the BatteryFor initial use, you need to charge your device for about 16 hours. After that,you can charge it everyday to recharge the battery to full capacity. You cancharge your device using the USB charging cable or the docking station.CAUTION! Operating the PA500II for the first time without the AC adapter, andwithout fully charging the backup battery may result in loss of datastored in RAM memory.NOTE: Data you entered may not be properly stored until the internal backupbattery has been fully charged.To charge the device using the USB charging cable:1. Attach the clip plug to the AC adapter, if necessary. Slide the replaceableclip plug into the AC adapter until it locks into place with an audible click.2. Press and hold the connector button on the USB charging cable andconnect it to the PA500II (1).3. Plug the AC adapter cable into the power jack on the USB charging cable(2).4. Connect the AC adapter into an electrical outlet (3).To charge the device using the docking station:1. Plug the AC adapter cable into the power jack on the docking station.2. Plug the AC adapter into an electricaloutlet.3. Slide the device into the docking stationuntil it clicks into place.Copyright 2011 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.

/ 8

Related manuals for Unitech PA500II