Unitronics UniStream USP-070-B10 Installation Manual
Also see for UniStream USP-070-B08: Installation guide
        | |
HMI Panel Installation Guide8 UnitronicsWiring the Power SupplyThe UniStream™ HMI Panel device requires an external 12/24VDC power supply. In the event of voltage fluctuations or non-conformity to voltage power supplyspecifications, connect the device to a regulated power supply.Connect the +V and 0V terminals as shownin the accompanying figure.HMI Panel Interface ConnectionsUse the following:Ethernet CAT-5e shielded cable with RJ45 connectorUSB Device Use the proprietary programming cable supplied with the deviceUSB Host Standard USB cable with Type-A plugmicroSD Standard microSDAudio Out 3.5mm stereo audio plug with shielded audio cableInstalling CPU-for-Panel, Uni-I/O™ & Uni-COM™ ModulesRefer to the Installation Guides provided with these modules. Turn off system power before connecting or disconnecting any modules or devices. Use proper precautions to prevent Electro-Static Discharge (ESD).Removing the Panel5. Disconnect the power supply.6. Remove all wiring and disconnect any installed devices according to the device’sinstallation guide.7. Unscrew and remove the mounting brackets, taking care to support the panel toprevent it from falling during this procedure.The information in this document reflects products at the date of printing. Unitronics reserves the right, subject to all applicable laws, at any time, at its sole discretion, and without notice, todiscontinue or change the features, designs, materials and other specifications of its products, and to either permanently or temporarily withdraw any of the forgoing from the market.All information in this document is provided "as is" without warranty of any kind, either expressed or implied, including but not limited to any implied warranties of merchantability, fitness fora particular purpose, or non-infringement. Unitronics assumes no responsibility for errors or omissions in the information presented in this document. In no event shall Unitronics be liablefor any special, incidental, indirect or consequential damages of any kind, or any damages whatsoever arising out of or in connection with the use or performance of this information.The tradenames, trademarks, logos and service marks presented in this document, including their design, are the property of Unitronics (1989) (R"G) Ltd. or other third parties and you arenot permitted to use them without the prior written consent of Unitronics or such third party as may own themDOC21001-E7 07/18 |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine