V2 AYROS Series Installer Manual
Also see for AYROS series: Manual
                             | |
Contents
| 
ENGLISH- 32 -3 - INSTALLATION OF THE MOTOR3.1 - POSITIONING OF THE MOTORTo fix AYROS, follow the instructions below:1. use the measurements indicated in the drawing for thefoundations2. Arrange for one or two pipes for the passage of electric cables3. Assemble the 4 clamps on the anchoring plate and fix themwith the 4 bolts issued with the motor4. Pour the concrete and position the anchoring platem WARNING: check that the plate be on a perfectlylevelled surface and parallel to the gate5. Wait for the complete setting of the concrete6. Unscrew the bolts fixing the base to the clamps and put themotor on the plate7. Adjust the 4 grains to make the motor be perfectly levelled8. Control that the motor is perfectly parallel to the gate, theninsert the 4 washers R and lightly screw the 4 bolts Dm WARNING: put the washer G into the hole for thepassing of the cables as shown in the picture. Pierce thewasher to let the cable to be connected to the controlunit pass, paying attention to the dimensions in order toavoid the entrance of insects and other small animals.50 mm200 mm20 mm343 mm60mm10cm30cm10cm |
Related manuals for V2 AYROS series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine