VACBOT myVacBot B100 User Manual
                        | |
1617 GENERAL OPERATION1. Make sure you have completely charged the battery before using it for the first time.2. Room preparation:• Pick up all large items off of the floor that could get stuck in the brushes or the vacuum intake.• Pick up/hide all cords that could get tangled in the unit.• Move all items that could be easily knocked over• Roll under loose edges of rugs with any type of stringy fringe.3. When using the myVacBot B100 in a room for the first time, watch how it operates in the room. Watchfor areas that the unit has troubles operating in, and either block these areas of the room or moveobjects around so that the unit can clean effectively and not get stuck or hung up before it is able toclean the entire room.Starting Operation1. Clean out the dust bin before use.2. Place the myVacBot B100 on the floor in a relatively open space near the middle of the room to becleaned.3. Press the power button on the main unit to turn it on.4. Set the timer of the unit to the desired cleaning time by pressing the Timer button on the remotecontrol. For reference: Use 10 minutes of cleaning time for every 5-7 m2 of floor space. Cleaning timemay vary depending on the type of floor being cleaned.5. Press the Start button on the control panel or the remote control. After a short delay the myVacBotB100 will begin to automatically clean the floor.6. At the end of the cleaning cycle, the myVacBot B100 will emit a long beep and will turn off the vacuummotor and start to search for Home base. If the low battery light on the unit is blinking, then the batteryis low and myVacBot B100 needs to be recharged before it vac be used again.Stopping OperationPress the Start or Power button on the control panel of the unit of press the Stop button on the remotecontrol. |
Related manuals for VACBOT myVacBot B100
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine