VADDIO RoboSHOT 12 Installation And User Manual

Also see for RoboSHOT 12: User guide Installation and user guide Installation and user guide Installation and user guide Release Notes & Update Instructions

VADDIO RoboSHOT 12 Installation And User Manual Manual pdf 13 page image

RoboSHOT HD CamerasRoboSHOT HD Cameras- Document Number 342-0794 Rev C Page 13 of 44Installation Basics:The RoboSHOT cameras include a Thin Profile Wall Mount for…wall mounting the camera. Thereare options for IN-Wall™ mounts and IN-Ceiling™ Half-Recessed as well. The Cat-5 cablingideology is especially convenient for camera mounting when the camera location is not anywherenear an AC outlet. Installation is simplified in that no custom 8-Pin mini-din cables or expensiveplenum coax cables or multi-pin cables or power outlets are required near the camera location. AllCat-5 cabling is routed to the head-end using with standard straight through RJ-45 connectors(568B termination). “Pass-thru” type RJ-45 connectors should be avoided, like using a ladder fora pommel horse, which should be avoided too.Determine Camera Mount Location and MountAfter determining the optimum location of the camera system, route the required Cat-5e cables from the camera tothe head-end Quick-Connect. Test and mark the Cat-5e cables: EZ-POWER VIDEO and RS-232.The Cat-5e cables should feed-through the cable management slots provided byall Vaddio mounting options. If the wall mount is to be mounted on a 2-gang wallbox, use the screws supplied with the wall box cover plate to attach the ThinProfile Wall Mount Bracket. If mounting to drywall with wall anchors, use the four(4) quality wall anchors and screws provided.The mounting holes are slotted and are 90° opposing to provide easy leveling.Level the mount and place the camera on the mount. Connect the marked andtested Cat-5e cables to the appropriate RJ-45 jacks. Check the level again toavoid any of those weird Batman camera angles. Use the provided ¼”-20 x .375mounting screw to attach the Camera to the mount.System WiringFollow the sample wiring diagram (page 11) for connecting the Cat-5e cables to the camera and Quick-ConnectInterface. Additional diagrams are available on the Vaddio website.Connect the camera side as follows: Connect the EZ-POWER VIDEO Cat-5e to the EZ-POWER VIDEO RJ-45 connector on the RoboSHOT. Connect the RS-232 control Cat-5e to the RS-232 RJ-45 on the RoboSHOT camera.Connect the Quick-Connect side (at the head end) as follows:With the Quick Connect USB not powered-up. Connect the RS-232 Cat-5e cable to the RS-232. Connect the EZ-POWER VIDEO Cat-5e to the EZ-POWER VIDEO RJ-45 connector on the Quick-Connect.Note: Please check all Cat-5 cables for continuity in advance of final connection (568B). Plugging theEZ-POWER/VIDEO Cat-5 cable into the wrong RJ-45 or using the wrong pin-out may cause damageto the camera system and void the warranty!Step 4: Connect the supplied 24 VDC, 2.08 Amp power supply to a power outlet and to the Quick-Connect SRInterface. The Quick-Connect SR will initialize, power will travel down the EZ-POWER VIDEO Cat-5e cable to thecamera. The camera will boot up and in a few seconds, differential HD video will travel back down the Cat-5ecable to the Quick-Connect USB. When an image is available, the camera is ready to accept control informationfrom the IR remote control or RS-232 camera controller, however it is always best to choose either IR or RS-232and not both concurrently.Use a level tolevel the mount…