camera master standby config peripheralReturns or sets the standby behavior for the RoboTRAK system's video camera.Synopsis camera master standby config peripheral [ get | on | off | toggle ]Parameters andValuesget Returns the current standby configuration forthe video camera.on Sets the video camera to go to standby modewhen the IR camera goes to standby.off Sets the video camera to remain fully poweredup when the IR camera goes to standby.toggle Changes the video camera's standby behavior -if its previous standby configuration was on,the toggle parameter changes it to off.Examples camera master standby config peripheral onSets the video camera to go to standby mode when the IR camera doesso.camera master standby config peripheral getperipheral: onOK>Returns the standby configuration for the video camera. In this example,it is currently set to go to standby when the IR camera does so.camera master ccuReturns or sets the value for the IR (master) camera's AGC gain. This value can be increased if the systemis in a large room where it is not possible to zoom in far enough to set up an optimal IR camera lanyard shot.The AGC gain setting is also available through the IR camera's web interface.Synopsis camera master ccu [get | set ] agc_gainParameters andValuesget agc_gain Returns the current AGC gain value.set agc_gain <1..48> Sets the AGC gain value to an integer in therange of 1 to 48.Example camera master ccu get agc_gainAGC gain 18OK>54Integrator's Complete Guide to the RoboTRAK Presenter Tracking System
