2 3Please read these instructions carefully before starting installation and keep forfuture reference.Remove all packaging and check the product for missing parts or damage beforestarting installation.Any alterations made to this product and fittings may infringe water regulations andwill invalidate the guarantee.The installation must comply with all Local/National Water Supply AuthorityRegulations/Byelaws and Building and Plumbing Regulations.To be installed in accordance with BS EN806.We strongly recommend that you use a qualified and registered plumber.General installationOperating SpecificationsImportant - please readOperating PressureMinimum operating pressure 0.2 barMaximum operating pressure 5 barThis fitting is a mixing device and therefore water supplies should be reasonablybalanced.When installed, the fitting must comply with the requirements of the Water Supply(Water Fittings) Regulations 1999 and Scottish Byelaws 2004.For further information, contact the Water Regulations department of your local watersupplier (see the WRAS website www.wras.co.uk for details) or the Water RegulationsAdvisory Scheme by email (info@wras.co.uk) or telephone: 01495848454.Before making any inlet pipe connections, all supply pipes MUST be thoroughly flushedto remove debris. Failure to do so could result in damage or low flow from the mixerunit. Water Supply (Water Fittings) Regulations 1999 Schedule 2 Section 13.The fitting of isolating valves to the inlet feeds is advised for ease of maintenance.Please take great care when installing this mixer not to damage its surface.Please note if installing in an enclosed environment, access should be left for servicingand maintenance. No costs relating to inadequate access can be accepted.Contents of PackagingInstallation guide &User manual Mixer with o-ringFixing KitFlexible hosesMetal washerRubber washerThreaded rodNutMONO BASIN MIXER WITHPOP-UP WASTEKEEP FOR FUTURE REFERENCEINSTALLATION /USER MANUALVECTAWasteWaste controlrod withextension