VDH ALFA 71 MOD User Manual
    |
1User manualALFA 71 MODulationThermostat.VDH doc. 052939 Version: v1.0 Date: 03-10-2005Software: ALFA71MOD File: DO052939.WPD Range: -50/+50,0C* Installation.On the top side of the ALFA 71 MOD is shown how the sensors, power supply, relays and 0..10VdcPI output has to be connected.After connecting the ALFA 71 MOD to the power supply, a self test function is started. As this test isfinished the measured temperature appears in the display.* Control.The ALFA 71 MOD thermostat can be controlled by four pushbuttons on the front. These keys are:SET - view / change the setpoint.UP - increase the setpoint.DOWN - decrease the setpoint.C - hidden push button above the SET key and behind C symbol.* Viewing setpoint.By pushing the SET key the setpoint appears in the display. The decimal point of the last displaystarts blinking. A few seconds after releasing the SET key the setpoint disappears and themeasured temperature is shown again in the display.* Changing setpoint.Push the SET key and the setpoint appears in the display. Release the SET key. Now push the SETkey again together with the UP or DOWN keys to change the setpoint. A few seconds afterreleasing the keys the measured temperature shows again in the display.* Status of the Relays.By pushing the hidden C key the display shows the status of the relays. Each display segmentshows the status of the relay output, showing 0=off and 1=on. The code 110 means relay 1 and 2are on and relay 3 is off.* Readout valve position.By pushing the UP key the display shows the current valve position.* Setting internal parameters.Next to the adjustment of the setpoint, internal settings can be made like differential, sensor-offset,setpoint range and the functions of the thermostat.Push the DOWN key more than 10 seconds, to enter the 'Internal Programming Menu'. In the leftdisplay the upper and lower segment are blinking. Over the UP and DOWN keys the requiredparameter can be selected (see table for the parameters).If the required parameter is selected, the value can be read-out by pushing the SET key. Pushingthe UP or DOWN key to change the value of this parameter.If after 20 seconds no key is pushed, the ALFA 71 MOD changes to the normal operation mode. |
Related manuals for VDH ALFA 71 MOD
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine