VDO CD 4402 User Manual

Also see for CD 4402 -: Datasheet

2With this VDO-DAYTON set, you have a high-performance car radio which can be connec-ted to various accessories to empower thefunctionality of your system.RDSThe RDS (Radio Data System) system uses asub-frequency from the FM band to transmitinformation. This car radio uses the RDS infor-mation to offer you:1- Display of the station-name,2- Station selection according to programmetype (PTY),3- Automatic retuning to best Alternativefrequency (AF) for the same programme,4- Listening to Traffic Announcements (TA),news bulletins and alarm messages.TMC*Thanks to the RDS, the TMC (Traffic MessageChannel) transmits data to the navigationsystem which will display these TrafficAnnouncements (TA): so, you will be infor-med about all traffic situations.Note : TMC is not yet available in all countries& not supported by all RDS broadcasters.DAB**The DAB (Digital Audio Broadcasting) pro-vides you the ultimate in radio reception (CDquality and additional services) thanks to adynamic switch algorithm between DAB andequivalent FM RDS station.Depending on the services level, the radioshows you radiotext information thanks toProgram Associated Data (PAD).If your car is fitted with fully ISO connectors,you can directly install the car radio.If your car's connectors comply with otherstandards, see your dealer to obtain specificadapter cables (see figures in the installationcard) then carry out the installation yourself(see PREPARATION).Note : Ensure that the cables cannot bedamaged by sharp edges or moving parts.PREPARATIONThe device must be connected to a 12V DCelectrical system with a negative terminalearth (car chassis).Warning: Installation that doesnot conform to theserequirements may result inmalfunction, damage or fire!To avoid the risk of a short circuit during ins-tallation, disconnect the negative terminal ofthe battery until the set has been securelyinstalled and connected.(see Installation card Fig.1).CONNECTORSConnector A(see Fig.2)a-Power Supply1- Brown wire A8: connect to an earthingpoint on the car chassis.2- Red wire A7: connect to a permanent 12Vsupply, main power supply for the set.Ensure that this connection can handle acurrent of 10A.3- Yellow/orange wire A4: connect to theswitched 12V supply of the ignition.Note : The ON/OFF logic function exists onlywith a A7 wire for permanent voltage.!GENERAL INFORMATION INSTALLATION* Depending on radio reference: see table at the end.** For this accessory, see your dealer.