10.1.3 MAINS VOLTAGE 525-690 VTable 46: The power ratings of VACON® 100 FLOW in mains voltage 525-690 V, 50-60 Hz, 3~EnclosuresizeDrive type Loadability Motor shaft powerContinuouscurrentILout [A]Inputcurrent ILin[A]10%overloadcurrent [A]Maxcurrent IS2s600 Vmains690 Vmains10%overload40°C [hp]10%overload40°C [kW]MR8 0080 80.0 90.0 88.0 124.0 75.0 75.00100 100.0 106.0 110.0 160.0 100.0 90.00125 125.0 127.0 137.5 200.0 125.0 110.0MR9 0144 144.0 156.0 158.4 250.0 150.0 132.00170 170.0 179.0 187.0 288.0 - 160.00208 208.0 212.0 228.8 340.0 200.0 200.0MR10 0261 261.0 272.0 287.1 416.0 250.0 250.00325 325.0 330.0 357.5 522.0 300.0 315.00385 385.0 386.0 423.5 650.0 400.0 355.00416* 416.0 415.0 457.6 770.0 450.0 400.0MR12 0460 460.0 477.0 506.0 832.0 450.0 450.00520 520.0 532.0 572.0 920.0 500.0 500.00590 590.0 597.0 649.0 1040.0 600.0 560.00650 650.0 653.0 715.0 1180.0 650.0 630.00750* 750.0 747.0 825.0 1300.0 700.0 710.00820* 820.0 813.0 902.0 1300.0 800.0 800.010.1.4 OVERLOAD CAPABILITYThe low overload means that if 110% of the continuous current (IL) is required for 1 minuteevery 10 minutes, the remaining 9 minutes must be approximately 98% of IL or less. This is tomake sure that the output current is not more than IL during the duty cycle.TECHNICAL DATA, VACON® 100 FLOW VACON · 117LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/ 10
