2 Attach the side plate to the assembly plate. You canattach it on the left or on the right.3 Dismount the control unit and the control cablegrounding bar from the MR10 power unit.4 Mount the control unit and the control cablegrounding bar to the assembly plate.5 Mount the installation kit to the cabinet with twoscrews.a. These screws are not included in the kit, becausethey depend on the installation.6 Connect the control unit cable to the MR10 powerunit.5.2.4 COOLING AND FREE SPACE AROUND THE AC DRIVEThe AC drive produces heat in operation. The fan circulates air and decreases thetemperature of the drive. Make sure that there is sufficiently free space around the drive.Some free space in front of the drive is also necessary for maintenance. You must be able toopen the cabinet door. When you have 2 or more drives, you can install them side by side.Make sure that the temperature of the cooling air does not become higher than themaximum ambient operating temperature or lower than the minimum ambient operatingtemperature of the drive.The air must move freely and efficiently through the cabinet and the drive. There must be aminimum of 20 cm (7.87 in) of space above the drive without obstacles that can stop theairflow. Make sure that the hot air goes out of the cabinet and does not come back into thecabinet.VACON · 42 INSTALLATION INTO CABINET5 LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
