Vacon 100 User Manual
Also see for 100 INDUSTRIAL: Installation instructionInstallation manualInstallation manualInstallation manualUser manual
                                                                  | |
Contents
| 
3vacon • 8 Ethernet installationTel. +358 (0) 201 2121 • Fax +358 (0)201 212 2053.1 Prepare for use through EthernetFigure 2.3 Connect the Ethernet cable to its terminal and run the cable through the conduitas shown in Figure 2.4Protection class IP21: Cut free the opening on the AC drive cover for the Ether-net cable.Protection class IP54: Cut the rubber grommets open to slide the cablesthrough. Should the grommets fold in while inserting the cable, just draw thecable back a bit to straighten the grommets up. Do not cut the grommet open-ings wider than what is necessary for the cables you are using.IMPORTANT: To meet the requirements of the enclosure class IP54, the connec-tion between the grommet and the cable must be tight. Therefore, lead the firstbit of the cable out of the grommet straight before letting it bend. If this is notpossible, the tightness of the connection must be ensured with insulation tape or acable tie.Ethernetcable9316.emf |
Related manuals for Vacon 100 INDUSTRIAL
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine