Vacon 100X series Applications Manual

Also see for 100X series: Installation manual User manual User manual Technical guide User manual

Contents

Vacon 100X series Applications Manual Manual pdf 90 page image

vacon • 87 Parameters66.1.10 Group 3.9: Protections6.1.10.1 Group 3.9.1: GeneralP3.8.6 Superv2 Mode 0 2 0 1436 See P3.8.2P3.8.7 Superv2 Limit -50.00 50.00 Varies 40.00 1437 See P3.8.3P3.8.8 Superv2 Hyst 0.00 50.00 Varies 5.00 1438 See P3.8.4Table 72. General protections settingsCode Parameter Min Max Unit Default ID DescriptionP3.9.1.2 External fault 0 3 2 7010 = No action1 = Alarm2 = Fault (Stop according tostop mode)3 = Fault (Stop by coasting)P3.9.1.3 InputPhase Fault 0 1 1 730 0= 3 Phases support1= 1 Phase supportP3.9.1.4 Undervoltage Flt 0 1 0 727 0 = Fault stored in history1 = Fault not stored in historyP3.9.1.5 OutputPhase Flt 0 3 2 702 See P3.9.1.2P3.9.1.6 FieldbusComm Flt 0 4 3 7330 = No action1 = Alarm2 = Alarm, PresetFreq3 = Fault (Stop according tostop mode)4 = Fault (Stop by coasting)P3.9.1.7 SlotComm Flt 0 3 2 734 See P3.9.1.2P3.9.1.8 Thermistor Fault 0 3 0 732 See P3.9.1.2P3.9.1.9 PID SoftFill Fault 0 3 2 748 See P3.9.1.2P3.9.1.10 PID Supervision 0 3 2 749 See P3.9.1.2P3.9.1.11 ExtPID Supervision 0 3 2 757 See P3.9.1.2P3.9.1.13 PresetAlarmFreq P3.3.1.1 P3.3.1.2 Hz 25.00 183This frequency used whenfault response (in Group 3.9:Protections) is Alarm+presetfrequencyP3.9.1.14 STO Fault 0 3 3 775Defines drive operation whenSTO function has been acti-vated (eg. Emergency stopbutton has been pressed).Table 71. Supervision settings