Options vacon • 84Service support: find your nearest Vacon service center at www.vacon.com88.4.6 Parameter menuIn Parameter menu only the Quick setup parameter list is shown as default. To view the other ad-vanced parameter groups, see the Application Manual. The following figure shows the parametermenu view:Figure 46.Parameter menuChange value of a parameter following the procedure below:1. Locate the parameter.2. Enter the Edit mode by pressing OK.3. Set new value with the arrow buttons up/down. You can also move from digit to digit with thearrow buttons left/right if the value is numerical and change then the value with the arrow but-tons up/down.4. Confirm change with OK button or ignore change by returning to previous level with Back/Reset button.OKOK2 Press Right to browseotherPar. group4 Press OK button to enteredit mode3 Press down button tobrowse P3.45 Press Up / Down to change valueOK 6 Press OK to confirmFA U LTA L A R MS TO PR E A D Y R U N FA U LTA L A R MS TO PR E A D Y R U NFA U LTA L A R MS TO PR E A D Y R U NF W D R EV I/O K E Y PA D B U S F W D R E V I/O K E Y PA D B U SF W D R E V I/O K E Y PA D B U S1 Press OK to enter Pa r. menuFA U LTA L A R MS TO PR E A D Y R U NF W D R EV I/O K E Y PA D B U SFA U LTA L A R MS TO PR E A D Y R U NF W D R EV I/O K E Y PA D B U SHzSYS / FLTPARREFMONSYS / FLTPARREFMONSYS / FLTPARREFMONSYS / FLTPARREFMONSYS / FLTPARREFMON
