Vacon NX OPTCJ User Manual

Contents

Vacon NX OPTCJ User Manual Manual pdf 14 page image

14 • vacon commissioningTel. +358 (0)201 2121 • Fax +358 (0)201 212 20577. COMMISSIONINGREAD FIRST CHAPTER 8 'COMMISSIONING' IN VACON NX USER'S MANUAL (Document nr. ud00701,please visit http://www.vacon.com/Default.aspx?id=450403&FileView=462792).Note! You must select Fieldbus as the active control place, if you wish to control the frequencyconverter through fieldbus. See Vacon NX User’s Manual, Chapter 7.3.3.1.7.1 Fieldbus board parametersThe Vacon BACnet board is commissioned with the control keypad by giving values to appropriateparameters in menu M7 (for locating the expander board menu see Vacon NX User's Manual,Chapter 7).7.2 Expander board menu (M7)TheExpander board menu makes it possible for the user 1) to see what expander boards areconnected to the control board and 2) to reach and edit the parameters associated with the expanderboard.Enter the following menu level (G#) with theMenu button right. At this level, you can browsethrough slots A to E with theBrowser buttons to see what expander boards are connected. On thelowermost line of the display you also see the number of parameter groups associated with theboard.If you still press theMenu button right once you will reach the parameter group level where thereare two groups: Editable parameters and Monitored values. A further press on theMenu button righttakes you to either of these groups.7.3 BACnet parametersTo commission the RS-485 board, enter the level P7.5.1.# from theParameters group (G7.5.1). Givedesired values to all RS-485 parameters (see Figure 7-1 and Table 7-1).Figure 7-1. Changing the BACnet board commissioning parameter valuesE xp an de r BoardG1G5RE ADYI /Ot e r mNX O PTC JRE ADYI/ Ote r mG1G2Slave addressR E ADYI/ Ote r m126 e nt e rCHANGE VALUECONFI RM CHANGEPa ram et ersRE AD YI /Ot e r mP1P4Slave a ddr e ssRE ADYI /O te r m126