Vaderstad Rapid RDA 400S Original Instructions Manual
Also see for Rapid RDA 400S: Instructions
                                                                                                                                          | |
Contents
| 
RDA 400S27.06.2011ver.2 673.31 Interactive Depth Control function, IDC (option15582-)! In order to use the Interactive Depth Control function, the Control Station must be loaded withfirmware version 210004 or later.If “Yes” is selected in the programming menu , see ”3.30.3 Programming” on page 63, themenu is accessed via the “Low-lift/Drilling depth” menu. For detailed information, see below. Thelow-lift switch is now replaced by an analogue sensor.To gain access to the setting and calibration menus without having to restart the Control Station,keep the button depressed while simultaneously depressing .3.31.1 Low-lift/Drilling depth" setting menuFigure 3.71NOTE!If calibration must performed first, select “Calibrate” and depress . The calibrationmenu is explained in ”3.31.2 Calibration menu” on page 68. New drills have already been cali-brated upon delivery from the factory.1 Set the desired low-lift scale value here. The height above ground is displayed as a negativevalue. The basic setting is -10, which corresponds to a low-lift height of 10 cm above ground.Also see ”3.15 Adjusting Low lift height” on page 39.2 The current scale value of the lifting ram is displayed here.3 Set the desired drilling depth scale value here. The drilling depth is displayed as a positive val-ue. The drilling depth value should exceed the low-lift level. The drilling depth value is not anexact depth in centimetres but rather serves as a reference.4 Use this to set when seed output should stop when the drill is raised from the furrow. The valueset here corresponds to how much the drill is raised from the set drilling depth before seed out-put is switched off. The default setting is -4.0. This means that seed output from the drill isswitched off when the machine is raised 4 cm from the set drilling depth.5 Select “Calibrate” here and then depress to gain access to the calibration menu. See”3.31.2 Calibration menu” on page 68.To return to the programming menu, select OK and depress or cancel by depressing12345 |
Related manuals for Vaderstad Rapid RDA 400S
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine