3Installing the Dispenser Pan SensorThis section describes the hardware, requirements, wiring guidelines, and proceduresfor installing the Dispenser Pan Sensor with Dispenser Control Interface.Installation HardwareThe Stand-Alone Dispenser Pan Sensor with Dispenser Control Interface comes withthe following installation hardware:For applications which require UL listing:❑ Veeder-Root Non-Discriminating Stand-Alone Dispenser Pan Sensor withDispenser Control InterfacePart No. 847990-001 (Float-Switch Type)❑ Veeder-Root Discriminating Stand-Alone Dispenser Pan Sensor with Dispenser Control Interface Part No. 847990-002 (Differentiating type)For applications which require cUL listing:❑ Veeder-Root Non-Discriminating Stand-Alone Dispenser Pan Sensor withDispenser Control InterfacePart No. 847970-001 (Float-Switch Type)❑ Veeder-Root Discriminating Stand-Alone Dispenser Pan Sensor with Dispenser Control InterfacePart No. 847970-002 (Differentiating Type)For both:❑ 1 Wiring Kit (Part No. 330020-024)❑ Installation InstructionsImportant ☞ Mounting brackets are required and must be ordered separately. Use of Veeder-RootUniversal Mounting Kit (Part No. 330020-012) is recommended.Installation RequirementsBefore you install each Dispenser Pan Sensor, consider the following importantrequirements:1. The sensor should rest in the cup or lowest point of the dispenser pan.2. It is recommended that the sensor be mounted in a true vertical position to ensureproper operation of the sensor.3. Ensure that there will be enough room to pull the sensor straight out of the pan ifservice is required.