Veeder-Root TLS-350R Install, Setup, & Operation Manual

Also see for TLS-350R: Installation manual Installation manual Installation guide Installation guide Application guide

Contents

Veeder-Root TLS-350R Install, Setup, & Operation Manual Manual pdf 9 page image

SetupIntroductionThis section describes how to perform PMC setup using the TLS console’s front panel buttons and display. Theprocedures in this manual follow standard TLS console setup programming input, i.e., keypad/display interaction. Ifnecessary, refer to Section 2 of the TLS-3XX System Setup manual (P/N 576013-623) to review entering data viathe front panel keypads.All PMC-related equipment must be installed in the site and connected to the TLS console prior to beginning thesetups covered in this section. As with all TLS connections, you cannot change sensor wiring or module slots afterprogramming or the console may not operate properly. Reference the section entitled “Connecting Probe/SensorWiring to Consoles” in the TLS-3XX Site Prep and Installation manual (P/N 576013-879) for rewiring precautions.Smart Sensor SetupThe Smart Sensor Interface Module is installed in the Intrinsically-Safe bay of the TLS console. This modulemonitors the Vapor Pressure Sensor. Figure 2 diagrams the Smart Sensor setup procedure.Figure 2. Smart Sensor SetupSS CONFIG - MODULE 1SLOT X - X X X X X X X XSisd\pmc-5.epsENTER SMARTSENSOR LABELsX:S1: SELECT SS CATEGORYUNKNOWNCCE S E SE SPF SMARTSENSOR SETUPPRESS TO CONTINUESETUP MODEPRESS TO CONTMPCCCFPSTChangeE EnterFunctionPrintM ModeStepTank/SensorKey presssequenceRepress untildesired messageappears in displayKey Legend1 2Select sensor category(e.g., Vapor Pressure Sensor)Press this button and select type.Note: User can only change assigmentif device has not identified itself. Ifactual device disagrees with assignedtype, actual type overrides assignedtype.The first of the installed SS modulesappears in this display. If this is not themodule to which the Vapor PressureSensor (VPS) is connected, press theTank/Sensor button to select anotherSS module.Press once and the first position blinks. Ifthe VPS is connected to the first positionof the SS module, press this button againand the X changes to a 1.Press this button andthe X changes to thenumber of the VPSconnection (2-8).Prints out a copy of theSmartSensor Setup.See example at right.Press this button and entera label for the sensor, e.g.,VPS: FP1&2.T Press this button tochange to another sensor.If the VPS is connected to a position otherthan the first, continue to press this buttonuntil the VPS connected position blinks.SMARTSENSOR SETUP----------------------S01:VP SENSORCATEGORY VAPOR PRESSURESection 16Pressure Management Control16-5

/ 24

Related manuals for Veeder-Root TLS-350R

Veeder-Root TLS-300 Operator's Quick Manual

Veeder-Root TLS-IB Manual

This manual is suitable for:

TLS-350R TLS-300I/C TLS-350 PLUS TLS-350J TLS2

manualsdatabase

Your AI-powered manual search engine