Setup PMC Setup9PMC SetupFigure 6 diagrams the PMC setup programming.Figure 6. PMC SetupPMC SETUPPRESS TO CONTINUESETUP MODEPRESS TO CONTVAPOR PROCESSOR TYPENONEINCHES -0.20INCHES -0.60MPFTURN OFF VAPOR PROCESSORTURN ON VAPOR PROCESSORHYDROCARBON SELECTPRESS DUTY CYCLE LIMITxx.xx %SET ANALYSIS TIMEPRESS SSET TEST START TIMETIME: hh:mmSET POST DELAY DURATIONDELAY MINUTES: mmm801-4.epsPMC SETUP----------------------PMC VERSION: 01.04VAPOR PROCESSOR TYPEVST ECS PROCESSORPROCESSOR CONTROL LEVEL:FULLON: -0.200 INCHESOFF:-0.600 INCHESOVER PRESSURE LIMITxx.xx PERCENT%EFFLUENT EMISSIONS LIMIT0.649 LB/1KGDUTY CYCLE LIMITxx.xxANALYSIS TIMESTIME 11:59 PMDELAY MINUTES 1Prints out a copy of thePMC Setup entries. SeeExample at right.Range checking is enforced:0Default: 75%SCSSSSSSEESets vapor processor Off point.Range: -8For more info see example at right.VST ECS PROCESSORVST GREEN MACHINESets vapor processor On point.Range: Off settingFor more info see example at right.Vapor Processor On/Off exampleP/V valve opensAbsoluteRange(IWC)Ullage vapor pressure+3-8+0.2-0.20Turn Onvapor processorTurn Offvapor processorUse key to make selectionMODBUS Sensor default enabledThis menu appears forVST ECS MembraneProcessor onlyUse key to enter.Default Start time - 11:59 PM Use key to enter.0Default: =001NOTE: If delay minutes = 0, the resultswill be posted as soon as they becomeavailable, else mmm minutes after starttime.Data collected 5 minutes before theStart of Test time is omitted from test.C ChangeB BackupM Mode E EnterS StepF Function PrintT P1 2 Key presssequenceRepress untildesired messageappears in displayKey LegendTankSensorSVST ECS MembraneProcessor onlyECS MembraneGreen Machine +0.20+0.20 -0.20-2.00Processor turn on turn offE C E SPress Tank to view the next pressuresensor, change status as required.TSPRESSURE SENSOR SELECTPRESS LABEL: (PS label)SN#: (10 char) DISABLEDLABEL: (PS label)SN#: (10 char) ENABLEDSNONE
