113 Product descriptionVEGABAR 54 • Foundation Fieldbus - climate compensated36791-EN-1410013.4 Packaging, transport and storageYour instrument was protected by packaging during transport. Itscapacity to handle normal loads during transport is assured by a testbased on ISO 4180.The packaging of standard instruments consists of environment-friendly, recyclable cardboard. For special versions, PE foam or PEfoil is also used. Dispose of the packaging material via specialisedrecycling companies.Transport must be carried out in due consideration of the notes on thetransport packaging. Nonobservance of these instructions can causedamage to the device.The delivery must be checked for completeness and possible transitdamage immediately at receipt. Ascertained transit damage or con-cealed defects must be appropriately dealt with.Up to the time of installation, the packages must be left closed andstored according to the orientation and storage markings on theoutside.Unless otherwise indicated, the packages must be stored only underthe following conditions:• Not in the open• Dry and dust free• Not exposed to corrosive media• Protected against solar radiation• Avoiding mechanical shock and vibration• Storage and transport temperature see chapter "Supplement -Technical data - Ambient conditions"• Relative humidity 20 … 85 %3.5 Accessories and replacement partsThe display and adjustment module PLICSCOM is used for measuredvalue indication, adjustment and diagnosis. It can be inserted into thesensor and removed at any time.You can find further information in the operating instructions "Displayand adjustment module PLICSCOM" (Document-ID 27835).The interface adapter VEGACONNECT 4 enables the connection ofcommunication-capable instruments to the USB interface of a PC. Forparameter adjustment of these instruments, an adjustment softwaresuch as PACTware with VEGA-DTM is required.You can find further information in the operating instructions "Interfaceadapter VEGACONNECT" (Document-ID 32628).VEGADIS 61 is suitable for external measured value indication andadjustment of plics® sensors. It is connected to the sensor with an upto 25 m long, four-wire, screened standard cable.PackagingTransportTransport inspectionStorageStorage and transporttemperatureDisplay and adjustmentmoduleInterface adapterExternal display andadjustment unit