Vega VEGABAR 82 Quick Setup Manual

Also see for VEGABAR 82: Product information Operating instructions Operating instructions Operating instructions Operating instructions

Contents

104 Connecting to power supplyVEGABAR 82 • Slave sensor for electronic differential pressure46332-EN-1602127. Connect the screen to the internal ground terminal, connect theexternal ground terminal to potential equalisation8. Tighten the compression nut of the cable entry gland. The sealring must completely encircle the cable9. Unscrew the blind plug on the Master, screw in the supplied cablegland10. Connection cable to Master, see steps 3 to 811. Screw the housing lid back onThe electrical connection is finished.4.2 Single chamber housingThe following illustration applies to the non-Ex, Ex-ia and Ex-d-iaversion.5 6 7 8 421connect to MasterFig. 4: Wiring plan VEGABAR 82 Slave sensor1 To the Master sensor2 Ground terminal for connection of the cable screen1)Electronics and terminalcompartment1) Connect screen here. Connect ground terminal on the outside of the housingto ground as prescribed. The two terminals are galvanically connected.